| PH | 5.0 |
| Storage Condition | 贮存时请注意密封保存，存放于干燥、通风处，常温下有效期为12个月。 |
| Physical and Chemical Properties | Chemical quality series products are milky white liquid. The emulsion has fine particles and excellent stability. It does not produce clots with ammonia and formaldehyde and can be placed for a long time. |
| Use | Uses CSF-6# for soft resin, suitable for bottom, middle finishing. CSF-7# for the hard resin, suitable for middle and upper finishing. The film is uniform, bright and transparent, and still has flexibility, adhesion, cold resistance, heat resistance and solvent resistance under high hardness. |
| Caution | Non hazardous materials, not edible, avoid contact with the eyes, can be transported as general chemicals. |
Using acrylate monomer as raw material, microparticle lotion polymerization was carried out through molecular design and particle design. Then the copolymer is treated with mildew proof materials to become a modified acrylate lotion, which is the finished product. Add deionized water and anionic surfactant to the reactor, stir and dissolve, heat to 80 ℃, and start adding the first layer of monomer methyl acrylate and a certain amount of ammonium persulfate as initiators. React at 80-90 ° C for 10 minutes, then add the second layer of monomer (methyl acrylate: styrene: butyl glycol diacrylate=100:25:1). After adding, add a small amount of initiator methyl persulfate, and add a certain amount of emulsifier and initiator. React at around 80 ° C for 40 minutes. After adding, heat up to 90-100 ℃ and keep it warm for 1 hour to obtain the product.
microparticle emulsion polymerization is carried out by molecular design and particle design using acrylate monomers as raw materials. Then the copolymer is treated with anti-mold materials to become a modified acrylate emulsion, which is the finished product. Add deionized water and anionic surfactant into the reaction kettle, stir and dissolve, heat to 80 ℃, add the first layer of monomer methyl acrylate and a certain amount of ammonium persulfate as initiator. The reaction was carried out at 80~90 ℃ for 10min. Start adding a second layer of monomer (methyl acrylate: styrene: diethylene glycol butyl diacrylate = 100: 25: 1), add a small amount of initiator methyl persulfate, and add a certain amount of emulsifier and initiator, and react at about 80 ℃ for 40min. After adding, the temperature is raised to 90~100 ℃, and the temperature is kept for 1h to obtain the product.